You use this to condense the diameter of wire chain without scratching or marring the surface of the wire.To use you simply place the beginning end of the wire chain with the start wire into the hole that most clearly matches the current diameter of the chain.Holding the...
- You use this to condense the diameter of wire chain without scratching or marring the surface of the wire.
- To use you simply place the beginning end of the wire chain with the start wire into the hole that most clearly matches the current diameter of the chain.
- Holding the drawplate in one hand, grasp the start wire with pliers and pull the chain through as many times as necessary to make the chain smooth and round.
- If you want to make smaller chain then simply repeat the same steps but gradually moving down the holes sizes.
- The drawplate can also be used for straightening single strands of wire and for hardening wire before use.
- Made from solid wood with a huge variety of 12 hole sizes from approx 1mm up to 8mm to suit every wire and chain type.
- A simple way to make wire based chain round & smooth and to condense the diameter of the chain without scratching or marring the wire.
- Includes complete directions for using the plate and can be used with any soft wire.
- 12 holes range in diameter from approximately 1-7mm.
|
Powered by
Manufacturer: N/A
SKU: dp12
